基于微结构阵列基板的高效顶发射OLED器件

王江南; 丁磊; 倪婷; 宁舒雅; 张方辉

doi:10.3788/YJYXS20193408.0725

您当前的位置：

首页 >

文章列表页 >

基于微结构阵列基板的高效顶发射OLED器件

材料与器件 | 更新时间：2020-12-14

- 基于微结构阵列基板的高效顶发射OLED器件
- High-efficiency top-emitting OLEDs based on microstructure array substrate
- 液晶与显示 2019年34卷第8期页码：725-732
- 作者机构：
  
  陕西科技大学电气与控制工程学院, 陕西西安 710021
- 作者简介：
  
  [ "王江南(1994-), 男, 浙江宁波人, 硕士研究生, 2016年于陕西科技大学获得学士学位, 主要从事于OLED器件方面的研究。E-mail:271889516@qq.com" ]
  [ "张方辉(1966-), 男, 山西曲沃人, 博士, 教授, 2008年于陕西科技大学获得博士学位, 主要从事于OLED、LED等的研究。E-mail:zhangfanghui@sust.edu.cn" ]
- 基金信息：
  
  国家自然科学基金(61605105);陕西省科技统筹创新工程计划项目(2011KTCQ01-09);陕西科技大学科研启动资金(2016BJ-01);陕西省教育厅服务地方专项计划项目(17JF006);National Natural Science Foundation of China(61605105);Innovation Project of Science and Technology Plan Projects of Shaanxi Province(2011KTCQ01-09);Research Start-up Funds of Shaanxi University of Science and Technology(2016BJ-01);Special Scientific Research Plan of Shaanxi Provincial Education Department(17JF006)
- DOI：10.3788/YJYXS20193408.0725
  中图分类号： TN383.1
- 收稿日期：2019-03-18，
  
  录用日期：2019-4-29，
  
  纸质出版日期：2019-08-05
- 稿件说明：
移动端阅览
王江南, 丁磊, 倪婷, 等. 基于微结构阵列基板的高效顶发射OLED器件[J]. 液晶与显示, 2019,34(8):725-732.

Jiang-nan WANG, Lei DING, Ting NI, et al. High-efficiency top-emitting OLEDs based on microstructure array substrate[J]. Chinese journal of liquid crystals and displays, 2019, 34(8): 725-732.
王江南, 丁磊, 倪婷, 等. 基于微结构阵列基板的高效顶发射OLED器件[J]. 液晶与显示, 2019,34(8):725-732. DOI： 10.3788/YJYXS20193408.0725.

Jiang-nan WANG, Lei DING, Ting NI, et al. High-efficiency top-emitting OLEDs based on microstructure array substrate[J]. Chinese journal of liquid crystals and displays, 2019, 34(8): 725-732. DOI： 10.3788/YJYXS20193408.0725.

摘要

为了提高顶发射OELD的效率，降低电压，基于纳秒激光刻蚀技术制备了一种用于顶发射OLED的低成本可重复的方形微结构阵列基板，在此基础上制备了顶发射OLED器件。实验发现，利用这种基板可以有效提高器件的出光效率，降低器件的驱动电压。其中，使用20 μm的方格微结构阵列基板的器件的最高效率达到66.7 cd/A，40 mA/cm

下亮度达到20 103 cd/m

，相比于未经刻蚀的无结构器件分别提高9.8%和6.9%；而使用40 μm的方格微结构阵列基板的器件驱动电压最低，在40 mA/cm

下为9.58 V，相较未经刻蚀的无结构器件降低了0.26 V。分析表明，器件光效的提升和驱动电压的降低主要有两点原因：首先由于基于微结构阵列基板制备的器件中存在褶皱结构，可以破坏器件的光波导，并且增大了器件面积而降低驱动电压；其次纳秒激光刻蚀产生的光栅条纹可以提高光提取效率，同时增强局部电场以提高电极的载流子注入能力。

Abstract

In order to improve the efficiency of the top emitting OELD and reduce the driving voltage

a low-cost reproducible square microstructure array substrate for top-emitting OLEDs was fabricated based on nanosecond laser etching technology. Based on this substrate

the green top-emitting OLED devices were fabricated. It is found that the microstructure array substrate can effectively improve the light extraction efficiency and reduce the driving voltage of the device. Among them

the maximum efficiency of the device using the 20 μm square microstructure substrate is 66.7 cd/A and the brightness is 20 103 cd/m

at 40 mA/cm

which is 9.8% and 6.9% higher than that of the normal device

respectively. The device based on the 40 μm square microstructure array substrate has the lowest driving voltage of 9.58 V at 40 mA/cm

which is 0.26 V lower than that of the normal device. The analysis shows that the improvement of the light efficiency of the device and the reduction of the driving voltage are mainly caused by two reasons. Firstly

due to the presence of the wrinkle structure in the device

the optical wave-guide mode of the device can be destroyed

and the device active area is increased to reduce the driving voltage. Secondly

the grating fringes made by the second nanosecond laser etching can improve the light extraction efficiency while enhancing the local electric field to improve the carrier injection capability of the electrode.

关键词

Keywords

references

HSU S F, LEE C C, HWANG S W, et al . Color-saturated and highly efficient top-emitting organic light-emitting devices[J]. Thin Solid Films , 2005, 478(1/2):271-274.

SCHUBERT E F, HUNT N E J, MICOVIC M, et al . Highly efficient light-emitting diodes with microcavities[J]. Science , 1994, 265(5174):943-945.

CAO J, LIU X, KHAN M A, et al . RGB tricolor produced by white-based top-emitting organic light-emitting diodes with microcavity structure[J]. Current Applied Physics , 2007, 7(3):300-304.

SAXENA K, JAIN V K, MEHTA D S. A review on the light extraction techniques in organic electroluminescent devices[J]. Optical Materials , 2009, 32(1):221-233.

PYO B, JOO C W, KIM H S, et al . A nanoporous polymer film as a diffuser as well as a light extraction component for top emitting organic light emitting diodes with a strong microcavity structure[J]. Nanoscale , 2016, 8(16):8575-8582.

PARK W Y, KWON Y, CHEONG H W, et al . Increased light extraction efficiency from top-emitting organic light-emitting diodes employing a mask-free plasma-etched stochastic polymer surface[J]. Journal of Applied Physics , 2016, 119(9):095502.

QU Y, COBURN C, FAN D J, et al . Elimination of plasmon losses and enhanced light extraction of top-emitting organic light-emitting devices using a reflective subelectrode grid[J]. ACS Photonics , 2017, 4(2):363-368.

RIEL H, KARG S, BEIERLEIN T, et al . Tuning the emission characteristics of top-emitting organic light-emitting devices by means of a dielectric capping layer:an experimental and theoretical study[J]. Journal of Applied Physics , 2003, 94(8):5290-5296.

ZHU X L, SUN J X, YU X M, et al . High-performance top-emitting white organic light-emitting devices[J]. Japanese Journal of Applied Physics , 2007, 46(7A):4054-4058.

WU Z J, ZHAI Y, GUO R X, et al . Red top-emitting organic light-emitting device with improved efficiency and saturated color[J]. Journal of Luminescence , 2011, 131(10):2042-2045.

SHIN T K, HO J R, CHENG J W J. A new approach to polymericmicrolens array fabrication using soft replica molding[J]. IEEE Photonics Technology Letters , 2004, 16(9):2078-2080.

SENN T, KUTZ O, WENIGER C, et al . Integration of moth-eye structures into a poly(dimethylsiloxane) stamp for the replication of functionalized microlenses using UV-nanoimprint lithography[J]. Pflügers Archiv Für Die Gesamte Physiologie Des Menschen Und Der Tiere , 1960, 270(6):628.

PERICET-CAMARA R, BEST A, NETT S K, et al . Arrays of microlenses with variable focal lengths fabricated by restructuring polymer surfaces with an ink-jet device[J]. Optics Express , 2007, 15(15):9877-9882.

SHI X B, QIAN M, ZHOU D Y, et al . Origin of light manipulation in Nano-honeycomb structured organic light-emitting diodes[J]. Journal of Materials Chemistry C, 2015, 3(8):1666-1671.

JEON Y P, CHOI Y H, KIM T W. Efficiency enhancement of organic light-emitting devices fabricated using a 1, 4, 5, 8, 9, 11-hexaazatriphenylene hexacarbonitrile silver electrode[J]. Journal of Nanoscience and Nanotechnology , 2015, 15(10):7791-7794.

YANG S Y, JIANG M X. White light generation combining emissions from exciplex, excimer and electromer in TAPC-based organic light-emitting diodes[J]. Chemical Physics Letters , 2009, 484(1/3):54-58.

SEINO Y, SASABE H, PU Y J, et al . High-performance blue phosphorescent OLEDs using energy transfer from Exciplex[J]. Advanced Materials , 2014, 26(10):1612-1616.

ADAMOVICH V I, CORDERO S R, DJUROVICH P I, et al . New charge-carrier blocking materials for high efficiency OLEDs[J]. Organic Electronics , 2003, 4(2/3):77-87.

SU S J, CHIBA T, TAKEDA T, et al . Pyridine-containing triphenylbenzene derivatives with high electron mobility for highly efficient phosphorescent OLEDs[J]. Advanced Materials , 2008, 20(11):2125-2130.

KWON S, LEE E H, KIM K S, et al . Efficient micro-cavity top emission OLED with optimized Mg:Ag ratio cathode[J]. Optics Express , 2017, 25(24):29906-29915.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

暂无数据