Wedge-shaped bevel microstructure prepared by dislocation and superposition exposure method

Li-wen DONG; Xiao-xin SONG; Ren-quan GU; Feng ZHANG; Guang-cai YUAN; Qi YAO; Zhi-jun LYU; wen-qu LIU; Zhao CUI

doi:10.37188/CJLCD.2020-0186

您当前的位置：

首页 >

文章列表页 >

Wedge-shaped bevel microstructure prepared by dislocation and superposition exposure method

Device Physics and Device Preparation | 更新时间：2021-03-23

- Wedge-shaped bevel microstructure prepared by dislocation and superposition exposure method
- Chinese Journal of Liquid Crystals and Displays Vol. 36, Issue 3, Pages: 398-404(2021)
- 作者机构：
  
  京东方科技集团股份有限公司, 北京 100176
- 作者简介：
- 基金信息：
- DOI：10.37188/CJLCD.2020-0186
  CLC： O647.2
- Received：15 July 2020，
  
  Accepted：22 October 2020，
  
  Published：2021-03
- 稿件说明：
移动端阅览
Li-wen DONG, Xiao-xin SONG, Ren-quan GU, et al. Wedge-shaped bevel microstructure prepared by dislocation and superposition exposure method[J]. Chinese journal of liquid crystals and displays, 2021, 36(3): 398-404.
DOI：

Li-wen DONG, Xiao-xin SONG, Ren-quan GU, et al. Wedge-shaped bevel microstructure prepared by dislocation and superposition exposure method[J]. Chinese journal of liquid crystals and displays, 2021, 36(3): 398-404. DOI： 10.37188/CJLCD.2020-0186.

摘要

本文研究了基于T公司生产的某型号正性光阻，采用错位叠加紫外曝光工艺，实现灰阶曝光效果的方法，最终得到具有特定角度的楔形斜面结构。光阻在进行紫外感光前后，对紫外光的吸收系数

会发生变化，根据朗伯比尔定律（Lambert-Beer law），将楔形斜面结构等效成台阶状结构，并通过实验计算出使该光阻发生光解反应的临界曝光能量

、光阻感光前后的吸收系数

和

'，并进一步根据等效模型结构得到错位叠加曝光过程中每步曝光所需能量大小。实验结果表明，使光阻进行分解反应的临界曝光能量

约为8 mJ，对紫外光的吸收系数

约为1.14。经过紫外感光后，光阻对紫外光的吸收系数

'降为原来20%，进一步根据计算得到的曝光能量进行实验，最终制作出所需的斜角为32°的楔形结构。错位叠加曝光的方法可以得到具有特定角度的楔形斜面微结构，而且该过程所需的曝光条件可以根据楔形角度进行计算。

Abstract

A kind of exposure method of dislocation and superposition was studied

which was based on a type of positive photoresist produced by T company. It can realize the effect of gray scale exposure by the method and finally a wedge-shaped bevel microstructure with specific angle was obtained. The absorption coefficient of a photoresist can be changed after irradiated by ultraviolet light. According to the Lambert-Beer law

the bevel structure can be equivalent into step structure

and then the critical exposure energy for the photoresist to react and the absorption coefficients of the photoresist can be calculated

which was irradiated by UV before and after

as well as the exposure energy for the dislocation and superposition method. Experimental results show that the critical exposure energy for the photoresist to react is 8 mJ

and the absorption coefficient

of the photoresist for ultraviolet light is 1.14

which will reduce for 20% after irradiated by ultraviolet light. With irradiating by the energy calculated

the photoresist can form the wedge bevel structure with taper angle of 32°. A specific wedge bevel structure by the dislocation and superposition exposure method can be prepared and the energy can be calculated according to the taper angle of bevel structure.

关键词

Keywords

references

王琼华, 梁栋, 宋呈群. 助视3D显示技术概述[J]. 真空电子技术, 2011(5): 7-10, 27.

WANG Q H, LIANG D, SONG C Q. Overview on glasses-based 3D display technologies[J]. Vacuum Electronics , 2011(5): 7-10, 27. (in Chinese)

王嘉辉, 邓玉桃, 苏剑邦, 等. 全高清裸眼3D显示效果的评价与测量[J]. 液晶与显示, 2013, 28(5): 805-809.

WANG J H, DENG Y T, SU J B, et al . Evaluation and measurement of display effect in full high resolution autostereoscopic display[J]. Chinese Journal of Liquid Crystals and Displays , 2013, 28(5): 805-809. (in Chinese)

尹慧娟. 液晶显示特定指向视角技术研究[D]. 合肥: 合肥工业大学, 2017.

YIN H J. Study on specific viewing angle technology for liquid crystal display[D]. Hefei: Hefei University of Technology, 2017. (in Chinese)

CHOIG J, GWAG J S. Optical design for reflective liquid crystal displays[J]. Molecular Crystals and Liquid Crystals , 2015, 613(1): 103-109.

王海宏, 焦峰, 马群刚. 高透过率透明液晶显示器研究与开发[J]. 液晶与显示, 2014, 29(6): 901-905.

WANG H H, JIAO F, MA Q G. Research and development of high transmittance transparent liquid crystal display[J]. Chinese Journal of Liquid Crystals and Displays , 2014, 29(6): 901-905. (in Chinese)

王海宏, 焦峰, 马群刚. 透明液晶显示器色度特性研究[J]. 现代显示, 2013(1): 13-16.

WANG H H, JIAO F, MA Q G. Research on chromaticity characteristic of transparent liquid crystal display[J]. Advanced Display , 2013(1): 13-16. (in Chinese)

崔铮. 微纳米加工技术及其应用综述[J]. 物理, 2006, 35(1): 34-39.

CUI Z. Overview of micro/nanofabrication technologies and applications[J]. Physics , 2006, 35(1): 34-39. (in Chinese)

彭钦军, 郭永康, 曾阳素, 等. 实时灰阶掩膜技术制作微透镜列阵[J]. 中国激光, 2003, 30(10): 893-896.

PENG Q J, GUO Y K, ZENG Y S, et al . Real-time grey-tone mask technique for fabrication of microlens array[J]. Chinese Journal of Lasers , 2003, 30(10): 893-896. (in Chinese)

DILL F H, HORNBERGER W P, HAUGE P S, et al . Characterization of positive photoresist[J]. IEEE Transactions on Electron Devices , 1975, 22(7): 445-452.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

Li-wen DONG

Xiao-xin SONG

Ren-quan Gu

Feng ZHANG

Guang-cai YUAN

Qi YAO

Zhi-jun LYU

Wen-qu LIU

Related Institution

BOE Technology Group Co.， Ltd.

AI问答

Address：No.3888 Dong Nanhu Road, Changchun, Jilin, China 130033 Postal code：130033
Tel：0431-86176059 Email：yjxs@ciomp.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 吉ICP备11002662号-17 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰