Stability is an index to measure the quality of Switching Power Supply.The main factor that influences the stability of voltage-mode is caused by error amplifier. Compared to voltage-mode
current-mode improves a lot but introduces new factors
especially the sub-harmonic oscillation. This paper designed a Boost circuit which can insure the stability of output voltage and meet the requirements of EL lamp. A current comparator with enable signal is used in this paper to instead of error amplifier.Specific analysis and simulation results of the circuit are available in this paper. The circuit can achieve a response time about 25
Guo Y N,Cheng W B,Kang S M,et al.Stability criterion and parameter perturbation chaos control in boost circuit //2009 4th IEEE Conference on Industrial Electronics and Application, Xi'an, China: IEEE Conference Publications,2009:2886-2890.
Hiran Y.A MOS current-mode boost DC-DC converter with the cuty-ratio-independent frequency characteristics //IEEE Asian Solid-State Circuits Conference, Jeju: IEEE Conference Publicootions, 2011:46-52.
Pressman A I,Billings K,Morey T. 开关电源设计 [M].北京:电子工业出版社,2005:17-22.
胡嗣云.EL的特性及驱动电路研究 [J]. 国外电子元器件,2003,(5):27-28.
Buti B, Nagy I, Ohsaki H, et al.Novel approach in stability analysis presented in controlled boost converter //Power Conversion Conference, Nagoya:IEEE Conference Publications,2007:581-587.
Roberto G,Josep F,Luis M,et al.Self-oscillating boost converter with output filter for Ideal load regulation //1996 IEEE International Symposium on Circuits and Systems, Spain:IEEE Conference Publication, 1996:529-532.